|
Shipping
By UPS
|
|
|
Sprinklers
|
Sprayhead nozzles made by Rain Bird, Hunter, Weathermatic, and Orbit use the same female threads on their spray nozzles and are compatible with each other. Toro uses a male thread and is NOT compatible with any other sprayheads. Read More...
Leaking sprinklers generally do not have anything to do with the sprinkler. The problem is from water in the pipe after the sprinkler system has been shut off or a problem with the valve. Here are the main causes and the solutions:A. Water in t Read More...
There are two reasons why there might be a wet spot around your sprinkler:
The most common reason is called “Low Head Drainage.” This is when the lowest sprinkler head on the zone leaks the wa Read More...
Hunter rotary sprinklers operate on a “gear drive” system. When in operation, water turns a small turbine in the base of the sprinkler, which drives a series of gears that cause the head to rotate. The Hunter gear drive mechanism is sealed f Read More...
The most common reason a pop-up sprinkler “sticks up” is because debris is in the pop up body, the riser is damaged, or the riser seal is worn. To fix this, unscrew the body cap, pull out the sprinkler assembly, and examine the parts. Clean Read More...
It could be that the filter screen to the sprinkler is partially blocked.
Remove cap and lift internal parts out of the body.
Rinse parts in a pail of clean water. (Filter is on the bottom of the part that was lifted Read More...
Irrigation Tips and Tricks
Toro professionals have compiled a list of tips to make designing, installing and maintaining your irrigation system easier. Benefit from our decades of experi Read More...
Pop-up sprinklers require water pressure to “pop up.” Either a broken irrigation pipe or worn sprinkler wiper seals will cause loss of water pressure. To determine which is causing the problem, turn the sprinklers on, then pull up on any spr Read More...
Capping or removing a sprinkler is done differently depending on whether or not you live in an area that freezes and requires the irrigation system to be winterized. Winterizing your irrigation system involves draining or blowing the water out of the sy Read More...
The only lubricant Rain Bird recommends with any of their equipment is water! Any other lubricant will cause dirt and other debris to attract and stick to the different parts of the sprinkler. Read More...
SingleStreams are designed to operate at 25-75 psi. The nozzle controls the amount of water flowing through the head. The smaller the pattern, the lower the flow rate. The lower the flow rate the more sensitive the sprinkler head is to having the proper Read More...
Why is the valve leaking? ** Make sure the water supply is shut off to the irrigation system prior to disassembling any portion of the valve to avoid injury. If water leaks to the sprinkler heads, check the following:
Dis Read More...
This is generally because of a ruptured or torn diaphragm in one or more of the control valves. Be sure that the valve is not installed backwards. Make sure the solenoid plunger is not stuck or missing. Remove the solenoid and check for debris or a miss Read More...
There are two reasons why a pop-up spray will leak water when the water is off. The most common reason is called “Low Head Drainage” this is when the lowest head on the zone drains the water from the lateral piping out of the sprinkler. If i Read More...
|
|
|
|
|
|
Qty
|
|
Description
|
1 EA
|
|
Hunter PGP Blue Nozzle Set *NEW*
|
8 EA
|
|
Hunter SS-530 Side Strip Nozzle 5' x 30' Coverage
|
6 EA
|
|
Hunter RCS-515 Right Corner Strip 5' x 15' coverage
|
4 EA
|
|
Hunter LCS-515 Left Corner Strip 5' x 15' coverage
|
Go To Cart...
|
|
|
|
